For information, see Enable or Disable SSID Broadcasts. To configure the wireless interface to send and answer SSID requests, select the Broadcast SSID check box.Wireless Settings for a Dual Radio Firebox For more information, see Create a Network Bridge Configuration.įor detailed instructions on how to bridge a wireless interface to the trusted interface, go to Bridge a Wireless Interface to the Trusted Interface. If you want your wireless users to be on the same network as your wired trusted or optional network, you must use a network bridge between the wireless interface and the trusted or optional wired interface. From the Interface Type drop-down list, select an interface type for this Access Point interface.įor more information on these interface types, see Wireless Device Configuration Options.In the Interface Name (Alias) text box, you can change the alias name of the interface or use the default name. ![]() The Wireless Access Point configuration dialog box appears. Adjacent to Access point 1 or Access point 2, or Access point 3, click Configure."defconf: accept to local loopback (for CAPsMAN)" dst-address=127.0.0. "defconf: accept established,related,untracked" connection-state=\Īdd action=drop chain=input comment="defconf: drop invalid" connection-state=\Īdd action=accept chain=input comment="defconf: accept ICMP" protocol=icmp # DHCP client can not run on slave interface!Īdd comment=defconf dhcp-options=hostname,clientid disabled=no interface=\Īdd address=192.168.88.0/24 comment=defconf gateway=192.168.88.1Īdd address=192.168.88.1 comment=defconf name=router.lan # DHCP server can not run on slave interface!Īdd address-pool=default-dhcp disabled=no interface=ether1 name=defconfĪdd comment=defconf interface=ether1 list=LANĪdd comment=defconf interface=wlan1 list=WANĪdd address=192.168.88.1/24 comment=defconf interface=ether1 network=\Īdd address=172.19.2.11/16 interface=bridge1 network=172.19.0.0 Tkip,aes-ccm mode=dynamic-keys supplicant-identity=MikroTik \ Set authentication-types=wpa-psk,wpa2-psk group-ciphers=\ Installation=outdoor mode=station-pseudobridge ssid=TELEA Set band=2ghz-b/g/n disabled=no frequency=2437 \ after the steps above are completed, laptop should have access to the rest of LAN (if laptop is configured with IP address from the same subnet).Ĭode: Select all # jan/02/1970 00:22:49 by RouterOS 6.45.7 You can test, if everything works, using your laptop/PC. you might want to configure firewall filter rules (chain=input) if you want to restrict management access to MT.You can read more about wireless modes in Manual:Wireless Station Modes. ![]() Set either mode=station-pseudobridge or mode=station-pseudobridge-clone and check which one works better. Set gateway as well in case you will want to perform ROS upgrades
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |